Add a touch of summer to your craft show table with soap pops made with this silicone mold! Create classic red, white and blue soap pops in July, or add fruity embeds and sweet scents for a colorful bar suitable all summer long.
Common Uses:
Melt & Pour Soap (MP). Cold Process Soap (CP). Cold Process Oven Process Soap (CPOP). Hot Process Soap (HP). Lotion Bars.
Points of Interest:
Maximum Temperature: 500ºF
Manufacturer: Crafter’s Choice®
Material: Silicone
Country of Origin: China
Country Of Origin: China
|  | This product is not on the CA Prop 65 list of toxic chemicals.
This product conforms to the reporting requirements of California Proposition 65 (Safe Drinking Water and Toxic Enforcement Act of 1986). We are conforming to the regulation by reporting the existence, or lack thereof, of ingredients deemed reportable by the above mentioned regulations via a Safety Data Sheet (SDS), in Section 15 "Regulatory Information." Ingredients from Natural Food Sources (NFS) and are exempt from reporting in accordance with Title 27, § 25501(a). |
|
|
|
Melt & Pour Soap: Pour melted soap into silicone mold cavities. Place lid on top of soap, and then insert popsicle sticks into each hole. Allow soap to cool at room temperature until hard. Carefully remove lid. Remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. DO NOT PULL FROM STICKS.
Cold Process Soap: Pour soap at trace into the mold cavities. Place lid on top of soap, and then insert popsicle sticks into each hole. After at least 24 hours, remove lid and gently pull silicone mold to loosen its grip on the soap. Gently push on the bottom of mold until the soap starts to release. Grab hold of the soap with a gloved hand, and allow soap to cure for 4-8 weeks. Note that some cp soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster. DO NOT PULL FROM STICKS.
Cold Process/Oven Process Soap: Pour soap at trace into the mold cavities. Preheat oven to 170ºF then place mold in oven. Turn oven off, and keep soap in oven overnight. The next day remove mold from oven. Place lid on mold and insert popsicle sticks into each opening. Remove lid. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. Allow soap to cure for 2 to 4 weeks. DO NOT PULL FROM STICKS.
Hot Process Soap: Scoop hot process soap into mold cavities. Gently tap the mold onto the counter to remove air pockets. Place lid on top of soap, and then insert popsicle sticks into each hole. Allow soap to cool and harden. (This can take up to 48 hours.) Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. DO NOT PULL FROM STICKS.
Lotion Bars: Pour melted lotion bar mixture into mold cavities. Place lid on top of soap, and then insert popsicle sticks into each hole. Allow mixture to solidify. Carefully remove lotion bars from mold by gently pulling the sides away from the lotion bars, and then push on the bottom of the mold until the lotion bars starts to release. Grab hold of lotion bar and carefully pull out of mold. DO NOT PULL FROM STICKS.
Care:
Hand wash in warm sudsy water.
|
