Beer Soap Mold (MW 536)

A hop flower sits in the center on this mold with the words "BEER SOAP" along the circular edges of each cavity. Barley also adorns the design. Use for your ale scented melt and pour soaps or for beer made cold process soaps.

Common Uses:
Melt & Pour Soap. Cold Process Soap.

Points of Interest:
Manufacturer: Milky Way Molds
Material: Clear PVC (Not Approved for Food Contact)

Milky Way Soap Molds can tolerate temperatures of 135-145 degrees F. Above these temperatures, warping may occur. Soap is easiest to release 12-24 hours after cooling.

Wash molds in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.

Country Of Origin: United States

Directions:

Melt & Pour Soap: Pour melted soap at a temperature no hotter than 135ºF into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.

Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Care:
Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.

Ingredients:

Available Sizes:

1 Mold $4.88
5 Mold $20.97
20 Mold $67.47
150 Mold (Bulk) $451.45