Ribbon Column Silicone Soap Mold 2029

Make ribbon shaped soaps to show your support to a cause! Embed the ribbon into a loaf to create soaps that raise awareness. Use the Teardrop Column Mold to create the middle of the ribbon (sold separately). Embed fits in Crafter's Choice Regular Loaf Silicone Mold 1501 and Rectangle Regular Column Silicone Soap Mold 2009.

Common Uses:
Melt & Pour Soap. Cold Process Soap.

Points of Interest:
Manufacturer: Crafter's Choice
Material: Silicone
Country of Origin: China

NOTE: To minimize bowing pour soap in layers.

Country Of Origin: China

This product is not on the CA Prop 65 list of toxic chemicals.

This product conforms to the reporting requirements of California Proposition 65 (Safe Drinking Water and Toxic Enforcement Act of 1986). We are conforming to the regulation by reporting the existence, or lack thereof, of ingredients deemed reportable by the above mentioned regulations via a Safety Data Sheet (SDS), in Section 15 "Regulatory Information." Ingredients from Natural Food Sources (NFS) and are exempt from reporting in accordance with Title 27, § 25501(a).

Directions:

Melt & Pour Soap: Close the mold by firmly pressing the edges together. For added safety, clamp the edges. Slowly pour melted soap no hotter than 130ºF into mold. Allow soap to harden then open mold and remove soap. Trim edges with a potato peeler or spatula. Embed soap into a loaf or slice into bars.

Cold Process Soap: Close the mold by firmly pressing the edges together, and clamp the edges. Slowly pour traced soap into mold. After at least 24 hours, open mold and remove soap with gloved hands. Trim edges with a potato peeler or spatula. Embed soap into a loaf or slice into bars. Allow soap to cure for 4-8 weeks. Note that some cp soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Care:
Hand wash mold in warm, sudsy water.

Ingredients:

International Nomenclature of Cosmetic Ingredients (INCI):
This product does need to be listed on the product ingredient label.

Common Name Ingredient Listing (FDA Approved):
This product does need to be listed on the product ingredient label.

Available Sizes:

1 Mold $14.07
5 Mold $59.07
50 Mold (Bulk) $924.95